PE Pipe accessories: FITTING SPECIFICATIONS.

FITTING
HOME > PRODUCT INDEX > FITTING

CONNECTIONS, ELBOWS, END STOPPERS, TEES

Catalogue & price list available in the ARCHIVES section.

New patented system thanks to the incorporation of improved technology achieved by our experience, research and development.

CHARACTERISTICS:

	System without joint adapter socket.
	Clamp design with arm, avoiding the traditional split clamp system, which has allowed us to improve into the fit of the clamp and tube. We obtain a better fastening with less force.
	Asymmetrical saw-tooth pattern if the clamp.
	Clamp and tube cannot rotate during tightening.
	To avoid loosing it, the clamp cannot fall off even if the nut is fully undone. The O ring is also immobilized by the clamp.
	The nuts contain a stop. During assembly, the operator feels that the optimun installation position has been reached, which prevents any over tightening.
	Fitting PN 16.
	For use in low, medium and high density tubes.
	Designed to conform to UNE standards relating to mechanical unions for polyethylene tubes.

MATERIALS:

	Body: polypropylene.
	Clamp: acetal resin.
	Nut: reinforced polypropylene.
	O ring seal: NBR.

ASSEMBLY:

	Loose the nut to the maximum without needing to take it off completely.
	IMPORTANT: Do not remove the clamp from its sealing. The clamp must be located on its lodging before introducing the tubing.
	Insert the tube ensuring it passes over the O ring seal and reaches the grooves inside the part.
	Tighten the nut up to the end of travel stop.

RECOMMENDATIONS:

	Cut the tube off square.
	Remove any imperfections from the outer edge of the part of the tube to be inserted into de fitting.
	Ensure that the tube is clean so that the O ring seal fits perfectly to the contour.
	Do not allow the tube to adopt a stressed position.


Loosen the nut almost to the end of the thread.	On inserting the tube, the pressure produced by the joint is felt initially, then passed, and the tube is then inserted up to the end stop.	Screw the nut up to the maximum.

PLASGOT, S.L. Rosa de los vientos, 74-76 03007 - Alicante España (Spain)	Tfo: 34 965 104 725 Fax: 34 965 104 842
E-mail: plasgot@plasgot.com Web: www.plasgot.com