Volver

HUNTER NOZZLES
HOME > PRODUCT INDEX > SPRINKLERS >HUNTER ARC AJUSTABLE NOZZLES

With an easy turn by hand – no tools are required to adjust – you can fine-tune Hunter Adjustable Arc nozzles from 25 to 360 degrees to keep the spray in the areas as designed. In addition, the radius can be reduced up to 25% without changing the pattern distribution. They are compatible with all sprinklers using female inlet, but Toro.
Today, more and more landscapes are calling for a nozzle that can be precisely set to handle meandering walkways or atypical, hard-to-handle sharp angles.

 

ARC ADJUSTMENT

  1. The Hunter Adjustable Arc nozzles come from the factory with a preset arc of 25°. Hold the perimeter of the nozzle with fingers and turn the nozzle counterclockwise to increase the arc. 

  2. To decrease the arc, hold the perimeter of the nozzle with fingers and turn the nozzle clockwise.

Note: The arc can also be increased or decreased by using a flat-bladed screwdriver


RADIUS ADJUSTMENT

  1. Hold the nozzle arc stationary with fingers, or with the two pins on the side of the Hunter wrench between any of the nozzle spokes.

  2. Adjust the radius with a flat-bladed screwdriver by turning the center screw clockwise to reduce the radius. 

Note: The radius should not be reduced more than 25%. The sprinkler is preset at the factory for maximum radius.

 

Performance table
(Push on the table to enlarge)

 

horizontal rule

PLASGOT, S.L.              
Rosa de los vientos, 74-76
03007 - Alicante                  
España (Spain)

Tfo:  34 965 104 725
Fax: 34 965 104 842

E-mail:    plasgot@plasgot.com       Web:  www.plasgot.com