Sprinkler irrigation. PS Spray Sprinkler

HUNTER PS SPRAY SPRINKLER
HOME > PRODUCT INDEX > SPRINKLERS > PS SPRAY SPRINKLER

Spray sprinkler with adjustable arc that creates arc patterns from 1 to 360 degrees. No other spray sprinkler with a single nozzle is this versatile! Or as dirt tolerant – the factory-installed extra-large filter screen traps the maximum amount of debris without interrupting flow and is easily removed for cleaning. Fast and easy to set up, the PS is designed to fit your budget as effortlessly as it fits your landscape.

	Arc adjustable one nozzle from 1º to 360º.
	Color-coded nozzle ID ring that permits quick identification of radius in field
	Heavy-duty wiper seal that eliminates flow-by.
	Super extra large filter screen that captures large debris without interrupting flow

	Ratio: - PS-10A: 3,0 m. - PS-15A: 4,6 m. (see table).
	Pop-Up: - PS-02: 5 cm. - PS-04: 10 cm.
	Arc Adjustment: 1º to 360º.
	Standard nozzle trajectory: approximately 15º.
	IRecommended pressure range: 1,4 to 2,8 bar.
	Connection: 1/2" bsp female inlet.

INSTALLATION

DO NOT REMOVE THE NOZZLE. The filter screen is accessible from the bottom of the riser. Install all sprinklers; align the raised dot on top of each nozzle with what will be the right edge of the spray arc (looking from “behind” the sprinkler).
Unscrew the internal assembly from the last head on each lateral line.
Flush the lines. Replace the internal assemblies.
Adjust arc and radius for each sprinkler, as described below.

ARC ADJUSTMENT

Insert the Hunter wrench by the key-end (or an Allen key of the same measure) into the arc adjustment socket and turn left to increase the arc. The nozzle turns at the same time, and the arc and the flow will be increased.

RADIUS ADJUSTMENT

Hold the plastic nozzle stationary by inserting the two pins on the side of a Hunter wrench between any of the nozzle spokes.
With a second Hunter wrench, turn the stainless-steel hex screw clockwise to decrease, and counter-clockwise to increase the radius and discharge rate.

NOTE: The radius should not be reduced more than 25%. (The sprinkler is pre-set at the factory for maximum radius.)

	Performance table (Push on the table to enlarge)